Applied the non skid pads to the step floor and the roll bar crossmember. Then masked around the non-skid pads. Used the grey stone finish and put a clearcoat over it after it dried. On the crossmember I measured 7/8" vice the 3/4" in the plans. The pads stick very well, you get ONE chance. A helper is useful here.
Then primed the fuel tank window area ensuring I masked all of the holes. Will apply the stone finish to this tiny bit on the fuel tank. After fuel tank assembly, I will be able to mask the window area and paint the remainder of the tank.
Time Today - 3 hours
