Electrical and Interior Painting

This morning I ensured both of the harnesses were as far forward as possible. Read a post on the VAF forums that indicated the harnesses will not run up and against the firewall if not done. Also, found a couple of needed but backordered female spade terminals in my tailcone kit. Added a ground wire to the 12VDC connector.

Then prepped all of the tunnel covers, the large tailcone cover and the seatbacks for primer. Primed them. Primed and final painted the flap handle with the powdercoat color that I have previously used in the interior.

Will spray the stone finish on the tunnel covers and the tailcone cover on Tuesday and then clear coat them the following day. That will leave the step area. Have to place the non-skid pads first and then mask, prime, paint/clearcoat. Then the majority of the interior paint will be complete.

Time Today - 5 hours