Response from Van's on the WH-RV12-OPTIONAL Harness

Q: Looking at the MAIN DB-25 pin connector on the WH-RV12-OPTIONAL harness. There is a white-black wire and a orange wire with female pins attached that are NOT inserted in the DB-25 connector. The wires are just hanging.

Received the following response from Gus at Van's.

"These wires are left unconnected, they may be needed for future changes to the Dynon. The wires are for Re-Dundant DSAB on future Dynon products. DSAB is Dynons own internal data tranfer protocol much like RS232. In the future both Data and Power etc will all be transferred on two wires between all Dynon units."

So I will leave them unconnected but have to extend at least one of them. This will allow be to heatshrink and then reach all of the locations in the DB-25. Will coil up the wires in the DB-25.